Bisphosphonate-related atypical femoral fracture: Managing a rare but serious complication

Contralateral fracture in more than one-fourth of cases

After an atypical femoral fracture, patients have a significant risk of fracture on the contralateral side. In a case-control study, 28% of patients with atypical femoral fracture suffered a contralateral fracture, compared with 0.9% of patients presenting with a typical fracture pattern (odds ratio 42.6, 95% CI 12.8–142.4).¹⁵

Contralateral fracture occurs from 1 month to 4 years after the index atypical femoral fracture.¹⁶

There are reports of bisphosphonate-related low-impact fractures in other sites such as the tibia¹⁷ and forearm.¹⁸ However, they may be too rare to warrant screening.

Mortality rates

A Swedish database study found that patients with atypical femoral fractures, whether bisphosphonate users or nonusers, do not have higher mortality rates than patients with ordinary subtrochanteric or femoral shaft fractures.¹⁹ Furthermore, the mortality rates for those with atypical femoral fracture were similar to rates in the general population. In contrast, patients with an ordinary femoral fracture had a higher mortality risk than the general population.¹⁹

Other studies suggest that atypical femoral fracture may be associated with a less favorable prognosis in older patients,²⁰ but this could be due to differences in demographics, treatment adherence, or postfracture care.²¹

In addition, functional outcomes as measured by independent mobility at discharge and at 3 months were comparable between patients with atypical fracture and those with typical fracture.²²

IMAGING STUDIES

If a long-term bisphosphonate user presents with hip, thigh, or groin pain, imaging studies are recommended.

Plain radiography

Radiography is usually the first step and should include a frontal view of the pelvis (Figure 1) and 2 views of the full length of each femur. If radiography is not conclusive, bone scan or magnetic resonance imaging (MRI) should be considered.

A linear cortex transverse fracture pattern and focal lateral cortical thickening are the most sensitive and specific radiographic features.^23,24 Because of the risk of fracture on the contralateral side, radiographic study of that side is recommended as well.

Computed tomography

Computed tomography (CT) is not sensitive for early stress fractures and, given the radiation burden, is not recommended in the workup of atypical fracture.

Bone scanning

Bone scanning using technetium 99m-labeled methylene diphosphonate with a gamma camera shows active bone turnover. Stress fractures and atypical femoral fractures are most easily identified in the third (delayed) phase of the bone scan. Although bone scanning is highly sensitive, the specificity is limited by lack of spatial resolution. Atypical femoral fracture appears as increased activity in the subtrochanteric region with a predilection for the lateral cortex.

Dual-energy x-ray absorptiometry

Conventional dual-energy x-ray absorptiometry (DXA) extends only to 1 to 2 cm below the lesser trochanter and can therefore miss atypical fractures, which usually occur farther down. The overall detection rate for DXA was 61% in a sample of 33 patients.²⁵

Newer scanners can look at the entire femoral shaft.²⁶ In addition, newer software can quantify focal thickening (beaking) of the lateral cortex and screen patients who have no symptoms. The results of serial measurements can be graphed so that the practitioner can view trends to help assess or rule out potential asymptomatic atypical femoral fracture.

A localized reaction (periosteal thickening of the lateral cortex or beaking) often precedes atypical femoral fracture. A 2017 study reported that patients with high localized reaction (mean height 3.3 mm) that was of the pointed type and was accompanied by prodromal pain had an increased risk of complete or incomplete atypical femoral fracture at that site.²⁷ This finding is used by the newer DXA software. The predictive value of beaking on extended femoral DXA may be as high as 83%.²⁶

Magnetic resonance imaging

The MRI characteristics of atypical femoral fracture are similar to those of other stress fractures except that there is a lateral-to-medial pattern rather than a medial pattern. The earliest findings include periosteal reaction about the lateral cortex with a normal marrow signal.

MRI may be of particular benefit in patients with known atypical femoral fracture to screen the contralateral leg. It should image the entire length of both femurs. Contrast enhancement is not needed.

Regardless of whether initial findings were discovered on conventional radiographs or DXA, MRI confirmation is needed. Radio­nuclide bone scanning is currently not recommended because it lacks specificity. Combination imaging is recommended, with either radiography plus MRI or DXA plus MRI.

DIFFERENTIAL DIAGNOSIS

The differential diagnosis of atypical femoral fracture includes stress fracture, pathologic fracture, hypophosphatasia, and osteogenesis imperfecta.²⁸ Hypophosphatemic osteomalacia can cause Looser zones, which can be confused with atypical femoral fractures but usually occur on the medial side.⁴ Stress fracture of the femur can occur below the lesser trochanter but usually begins in the medial, not the lateral, cortex.

Pathologic fractures from underlying osseous lesions can mimic the cortical beaking of bisphosphonate-related fracture, but they usually show the associated underlying lucent lesion and poorly defined margins. A sinus tract along the region of a chronic osteomyelitis may also appear similar.

Hypophosphatasia is an inborn error of metabolism caused by a loss-of-function mutation in the gene encoding alkaline phosphatase, resulting in pyrophosphate accumulation and causing osteomalacia from impaired mineralization. This can result in femoral pseudofracture that is often bilateral and occurs in the subtrochanteric region.²⁹